Table of Contents
Advertisement
INSTALLER GUIDE
16. TRIM & FRAMELESS INSTALLATION
1. Trim
Ensure the four magnets supplied on the rear of the trim are loacted one into each
corner. Laid them flat against the inside corner surface of the trim. Offer the trim
towards the fire, the trim secures with the magnets to the outside metal return on the
outer convector box.
Push the trim tight up to the fire ensuring that the magnets are fully incontact and
holding the trim in place.
2. Frameless
The frameless trim is pre fitted with screws securing it onto the outside face of the fire
with sealing tape along its base already sealing the frame to the convector box.
NOTE: During installation the additional length of foam seal is required to be fitted on
top of the sealing tape (Refer to section 11.3).
©
Page 36
GDC Group Ltd. NOV 2017
Advertisement
Table of Contents
