Optional Trim Installation - Valor Legend 736XN Installer's & Owner's Manual

2.1.6 Check Ignition Electrode Spark
Pilot ignition is by a spark produced when the control knob is
pushed in and turned counterclockwise to the "IGN" position.
Check that two consecutive sparks are produced at the pilot
burner. If there is no spark, check that the wiring is secure.
Replace parts if necessary. see figure 9.
2.2 INSTALL TO THE FIREPLACE
2.2.1 Connect the Chimney Liner
Connect the collar on the vent connector unit to the 4"
diameter chimney liner.
2.2.2 Insert the Fire Unit
Solid Fuel Fireplace Installation: Slide the fire unit into the
fireplace making sure that the vent connection unit is above
the appliance case. Leave the case front a few inches clear of
the fireplace front to allow you to fix the vent connector to the
top of the case.
Zero Clearance Installation: Accessory kit #700ZCK
(supplied separately) allows the appliance to be installed with
a 4" diameter type B-1 metal vent recessed into a wall or
partition in a chase (see figure 3). The maximum horizontal
vent pipe length is 8ft and the minimum vertical vent pipe
height is 8ft. For full details please contact your dealer.
Prepare the appliance and install in position in accordance
with the instructions supplied with the kit.
2.2.3 Attach the Vent Connector
Swing the vent connector backwards and locate its rear edge
in the slot at the top rear of the appliance case. Fix the front of
the vent connector plate to the appliance case top using the
screw previously removed. See figure 10.
2.3

OPTIONAL TRIM INSTALLATION

2.3.1 #677FSK 4" Beveled Trim
1. Assemble the two outer surround sides to the top
cross piece using the four nuts, screws and washers
provided. See figure 11.
2. Place the assembled trim in position against the
heater. Secure to the heater front flanges with screws
through two holes on the inner flanges of each of the
surround sides. See figure 12.
3. If required, fit the #740 beveled brass outer trims
over the 4" trim. Secure with the edge clips using
four across the top and three each side.
Figure 9. Pilot Ignition System
Figure 10. Vent attachment
Figure 11. 4" Beveled Trim Assembly
Figure 12. 4" Beveled trim Attachment
6