Flame Height - Valor Portrait 530ILN/ILP Installation & Operating Instructions Manual

Direct vent gas fireplace heater
Hide thumbs Also See for Portrait 530ILN/ILP:
Table of Contents

Advertisement

Turning your fireplace OFF
1.
Press the
(small flame) button to reduce the flame to pilot.
Press the OFF button to turn the pilot off.
Alternately, you can press the O button on the switch if you won't use your fireplace for a long period of time, if you cannot
locate your remote control handset or if you wish to change the batteries.
Operation Modes
STANDBY MODE—Ignited pilot only.
MAN MODE—Manual Mode. You can use this mode to adjust the flame height up or down.
man
TEMP MODE—Daytime Temperature Mode (appliance must be in Standby mode; pilot ignited): The room temper-
temp
ature is measured and compared to the set temperature. The flame height is then automatically adjusted to achieve the
Daytime set temperature.
TEMP MODE—Nighttime Setback Temperature Mode (appliance must be in Standby mode, pilot ignited): The room
temp
temperature is measured and compared to the Nighttime Setback temperature. The flame height is then automatically
adjusted to achieve the Nighttime Setback temperature.
TIMER MODE—(appliance must be in Standby mode, pilot ignited): The Timer setting allows you to set two burner
timer
ON times and two burner OFF times for every 24-hour period.
Changing the Mode of Operation
Briefly pressing the SET button changes the mode of operation in the following order:
man
temp
temp
NOTE: MAN mode can also be reached by pressing either the
Mode
Sun
TEMP
Daytime temperature setting
TIMER
Start time setting

Flame Height

The flame height can be adjusted in the following manners. In STANDBY mode,
1.
Press the
(large flame) button to turn on the main burner.
.
Press the
(large flame) button to increase the flame height.
.
Press the
(small flame) button to decrease the flame height or to go to pilot Standby position.
For fine adjustments, tap the
Quick Flame Adjustment
If
or
are pressed for 0.5 sec., the flame will increase to maximum or decrease to the pilot Standby position.
NOTE: While pressing either button, a symbol indicating transmission appears on the upper right hand corner of the dis-
play. The receiver confirms transmission with an acoustic signal.
Owner's Information
and back to
timer
Moon
Nighttime temperature setting
Stop time setting
and
buttons.
.
man
or
buttons.



Advertisement

Table of Contents
loading

This manual is also suitable for:

Portrait 530icn/icp

Table of Contents