Settings Data/Backing Up Or Restoring Logs [Data] - Panasonic WV-X6531N Operating Instructions Manual

2 Settings
[Reset to the default (Except the network settings)]
Click the [Execute] button to reset the settings to the default. Note that the network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Load the default HTML files (setup menu).]
Click the [Execute] button to reset the HTML files to the default.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reset to the default and load the default HTML files.]
Click the [Execute] button to reset the settings of the camera and the HTML files to the default. Note that the
network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reboot]
Click the [Execute] button to reboot the camera. It is impossible to operate the camera for about 2 minutes
after rebooting the camera.
[Position refresh]
The camera position can be refreshed.
When the camera has moved from the correct home/preset position during normal use, or when it has been
inadvertently moved while turning on the power of the camera, use this function to correct the camera position.
It is impossible to operate the camera during the position refresh process for about 2 minutes.
IMPORTANT
•
The direction of the camera may be accidentally changed when the camera is installed. When
registering presets after the installation, we recommend performing position refresh.
Note
•
To initialize the network settings (®Page 180), turn off the power of the camera, and then turn on the
power again after turning on the INITIAL SW on the camera. Wait about 2 minutes after releasing the
button. The camera will start up and the settings including the network settings will be initialized. Do
not turn off the power of the unit about 3 minutes after turning on the power. After the initialization is
complete, turn off the power of the camera, and then turn off the INITIAL SW.
•
The notification function allows users to provide the notification of the error to the specified destination
E-mail address and an original alarm destination when an error such as no SD memory card insertion
after the reboot or a locked SD memory card insertion occurs. (®page 186, page 169)

2.11.5 Settings data/backing up or restoring logs [Data]

Click the [Data] tab of the "Maintenance" page. (®For menu display and how to operate, refer to page 47,
page 48)
240 Operating Instructions