Channel Profile Inputs - Tait TB8100 User Manual

198 Part I: Task Manager
External channel select enabled
The override input External channel select enabled becomes true when
Task Manager sets the H/W channel select flag. This occurs on entering Run
mode and if a Task Manager task enables power saving after a previous task has
disabled it.
Example
IF NOT External channel select enabled THEN Go to channel 2
This example specifies the channel that the TB8100 will operate on if a Task
Manager action disables external channel selection. This is another way of
specifying the channel in software; you can also select a channel as the default.
Syslog service enabled
The override input Syslog service enabled becomes true when Task Manager
turns the Syslog service system flag on. This occurs on entering Run mode and
if a Task Manager task enables the syslog service after a previous task has
disabled it. When the syslog service system flag is on, the base station sends
syslog messages according to the configuration in Configure >
Communications > Syslog.
Power saving enabled
The override input Power saving enabled becomes true when Task
Manager turns the Power save system flag on. This occurs on entering Run
mode and if a Task Manager task enables power saving after a previous task has
disabled it.
Timer expired
A timer can only be started by the Task Manager action Start timer. It expires
when the timer's maximum time has elapsed. This time was entered in
Configure > Task Manager > Timers.
Example
IF Timer expired (Weekly Email) THEN Email status now.
This input can be used to set up regular actions such as emailing the status
message.
Tx relay enabled
The override input Tx relay enabled becomes true when Task Manager turns
the Tx relay system flag on. This occurs on entering Run mode and if a Task
Manager task enables power saving after a previous task has disabled it.

Channel Profile Inputs

Channel profile inputs relate to configuration items that are defined in channel
profiles. You can put tasks with a channel profile input into the folder for a
particular channel profile or into the General folder. If the task is in a channel
profile folder, it is only processed when the current channel uses that profile. It
the task is in the General folder, it is always processed.
© Tait Electronics Limited December 2007