Modifying Access Profiles; Logging Off And Disconnecting - Tait TB8100 User Manual

Modifying Access Profiles

Logging Off and Disconnecting

TB8100 Service Kit User's Manual
Those with Administrator access can configure the access profiles of those with
a 'User' access level. One access profile is for local (direct) connections, the
other for remote (dial-up) connections. You could for example allow these
users to carry out diagnostic tests but only to view the base station's
configuration.
To modify an access profile
1. Log on to the base station as 'Administrator.'
2. Select Base Station > Access Profiles. The Service Kit reads access profile
information from the base station and displays it in the Access Profiles dialog
box.
3. Make changes to any settings in either tab.
4. Click OK to program your changes into the base station and close the dialog
box.
When you have finished working with a base station, click Disconnect to log
off and disconnect from the base station.
If the base station is in Standby or Download mode, you are reminded of this
and asked to confirm that you want to proceed. This is to make sure that you
do not inadvertently leave the base station out of service when you end a
Service Kit session. Select No to cancel disconnecting, and then change the base
station's mode back to Run before disconnecting.
Logging Off and Disconnecting 55