Advertisement
Rio1608-D
■ TEST PROGRAM
1. Preparation
1-1.
Required items
• Rio1608-D (Subject to test)
• Rio1608-D (Test jig): 1 unit
• Ethernet (CAT5e) Straight cable: 3 pcs.
• PC: 1 unit, Windows XP with Ethernet port Windows
Vista or Windows 7
• Switching Hub: 1 unit
1-2.
Network setting
[Control panel] → [Network connection] → [Local area
connection] → [Property] → Select Internet Protocol (TCP/IP)
→ [Property]
1-2-1. Open the property of the internet protocol
(TCP/IP).
1-2-2. Check "Use the next IP address" and make IP
address settings.
IP address:
Sub-net mask:
Default gateway:
1-2-3. Check "Use the next DNS server address" and
make DNS server settings.
Priority DNS server:
Substitute DNS server:
1-2-4. After above settings are completed, select
[OK] and the IP address is changed.
* Do not connect to house LAN or Internet.
1-3.
Application
Download the following applications from YSISS website and
install to the PC.
• Applications for Service Test
DiagRio1608-Service.exe
DiagRio1608-Service.ini
DiagRio1608-Service-ver.ini
38
192.168.0.101
255.255.255.0
No setting
No setting
No setting
1-4.
Connection
PC
Switching
Hub
1-5.
Settings and starting of DIP switch and UNIT ID
switch
• NETWORK terminal DIAG startup mode
Make settings for the DIP switch and UNIT ID switch of
Rio1608-D (subject to test) and Rio1608-D (Test jig).
* Turn off the power when setting the DIP switch. If the
power is turned on, no setting will be refl ected.
1)
Set the DIP switch to the DIAG mode by setting No.4, 7, and
8 to the on position (down) and others to the off position.
2)
Set the UNIT ID switch.
ID: 0 (Rio subject to test)
ID: B (Rio, test jig)
Rio1608-D (subject to test)
Rio1608-D (Test jig)
3)
Turn on the power switch of Rio.
4)
When started in the DIAG mode, all the signal indicators
flash in green. If all the signal indicators do not flash,
the peripheral circuit of the signal LED may have some
problem.
Rio1608-D (subject to test)
Rio1608-D (Test jig)
Advertisement
Chapters
