Change Password - Moxa Technologies ioLogik E1200 Series User Manual

ioLogik E1200 Series
When Trigger = Smaller, Value = 400, and Hysteresis = 200, the SNMP trap will only be triggered if the TC
signal fluctuates from 600 to 400, like in scenario 1. If we change to Value = 400 and Hysteresis = 400, the
SNMP trap will only be triggered if the TC signal fluctuates from 800 to 400.

Change Password

For all changes to the ioLogik E1200's password protection settings, you will first need to enter the old
password. Leave this blank if you are setting up password protection for the first time. To set up a new
password or change the existing password, enter your desired password under both New password and
Confirm password. To remove password protection, leave the New password and Confirm password
fields blank.
ATTENTION
If you forget the password, the ONLY way to configure the ioLogik E1200 is by using the Reset button to load
the factory default settings.
Before you set a password for the first time, it is a good idea to export the configuration file when you have
finished setting up your ioLogik E1200. Your configuration can then be easily imported back into the ioLogik
E1200 if you need to reset the ioLogik E1200 due to a forgotten password or for other reasons.
3-27
Using the Web Console