Function Group Service - Siemens SITRANS F M TRANSMAG 2 Operating Instructions Manual

Functions

7.7 Function Group Service

You delete text by selecting the end of text character from the character set with the
operating elements and then actuating the
the end of text character are then deleted.
Note
When the
glass panel), the characters are scrolled automatically.
Manufacturer data, menu item 5.2
You can read out the serial number, order number and software version of the device in the
individual menu items.
The serial number and the MRPD of the device electronics are always displayed; in case of
replaced electronics the latter is different from that of the device rating plate.
● Nominal width, menu item 5.2.6.2
7.7 Function Group Service
Enter Code (menu item 6.1)
You can disable the control and display unit with a personal, freely selectable code number
to prevent programming of the device by unauthorized persons. By entering the appropriate
code number in this menu item, the programming is enabled and you can change the device
settings.
● Factory set code "0"
● Customer code (see menu item 6.2 "Code change")
Note
If you actuate one of the
you are automatically prompted to enter the code in the device display. The programming
is disabled after returning to the display mode. The programming can also be disabled by
entering any number which does not match the actual customer code in this menu item.
After input of '3333' the fixed personal code is briefly displayed (help function as
reminder).
58
and operating elements are actuated continuously (your finger stays on the
In this menu item you can set the nominal width in older generations of sensors manually
if no SmartPLUG data are available.
When you have selected "Probe", you must enter the interior diameter of the surrounding
tube in "Diameter".
operating element. All inputs to the right of
or operating elements in the setting level of the parameter,
Operating Instructions, 11/2009, A5E00102775-07
and
SITRANS F M TRANSMAG 2