Function Group Diagnostics - Siemens SITRANS F M TRANSMAG 2 Operating Instructions Manual

Functions

7.3 Function Group Diagnostics

This menu displays all totalizers which can all be reset together.
These are:
● Totalizer forwards, menu item 1.4.1
● Totalizer reverse, menu item 1.4.2
● Totalizer net, menu item 1.4.3
● Set (all), menu item 1.4.4
Note
The totalizers show the total flow volume since starting the measurement. Use the menu
items 3.2, 3.3 and 3.4 for separate setting and resetting of the units. The totalizer is
restarted when it overruns.
Note
The value range of the totalizers in PROFIBUS and HART communication is principally -
10
999 999, the display stays at 999 999 999 when this range is exceeded, while totalizing
continues internally.
Flow velocity (menu item 1.5)
Display of current measured value in m/s
Frequency (menu item 1.6)
Display of current measured value in Hz
Analog Out1,2 (menu item 1.7)
Display of current measured value in mA
7.3 Function Group Diagnostics
Device status (Menu item 2.1)
During normal operation, test routines are run continuously.
The display "OK" appears in the case of error-free operation after selecting menu item 2.1
(device status). An error message is displayed in clear text in the event of an error.
The possible error messages are listed in the table below and the assignment of the error
messages to the individual outputs specified. The error message can only be output via the
digital outputs 1 and 2 and the analog output if configured accordingly (selection of 'Alarm'
function for the digital outputs or 'Failure signal' for the analog output) (see menu items
4.1.2, 4.2.1 and 4.3.1).
40
m to +10 m . However, since the value range of the local display is limited to 999
38 3 38 3
SITRANS F M TRANSMAG 2
Operating Instructions, 11/2009, A5E00102775-07