Write Protection - Siemens SITRANS F M TRANSMAG 2 Operating Instructions Manual

Commissioning

6.2 Write protection

Line
Leitungs-
abschluss
termination
T
B edien- und
HMI module
B eobachtungs-
(control and
m odul
display)
Figure 6-3
System requirements (SIMATIC PDM)
The PC must have the following minimum equipment to operate via SIMATIC PDM:
● Hardware:
● Software:
6.2 Write protection
The local display can be write-protected to prevent unauthorized manipulation by entering a
freely selectable, personal code number.
In this case the device functions and parameters can only be changed after entering this
code. You define the personal code number in the "6.2 Customer code" menu item.
If you actuate the
prompts you to enter the code. You can also enter the code number in the "6.1 Enter Code"
menu item. The programming is disabled again:
34
FG
max. 31
m ax. 31
weitere G eräte
other devices
System integration via Profibus
– Pentium processor or higher
– At least 32 MB RAM
– Hard disk with at least 110 MB free capacity
– Monitor: VGA standard or compatible with MS-Windows
– Keyboard and (optional) mouse
– CD-ROM drive
– Interface CP5411 A2 or CP5511 or CP5611
– Windows98, Windows NT4.0 or Windows2000
– SIMATIC PDM V5.01 or higher (SIMATIC STEP 7 OEM included)
Note
Operation of SIMATIC PDM is supported by integrated help functions.
and
DP/PA coupler
DP/PA-Koppler
oder Link
or link
PA
T
Strom -
versorgung
D P
PC /Laptop PC/laptop with
m it PRO FIBUS-M aster
PROFIBUS-Master
operating elements in the parameter setting level, the display
Power
supply
SITRANS F M TRANSMAG 2
Operating Instructions, 11/2009, A5E00102775-07