Function Group Service - Siemens SITRANS F TRANSMAG 2 Operating Instructions Manual

Electromagnetic flometers
Table of Contents

Advertisement

The serial number and the order number of the device electronics are always displayed; in case
of replaced electronics the latter is different from that of the device rating plate.
• Nominal width, menu item 5.2.6.2
In this menu item you can set the nominal width in older generations of sensors manually if
no SmartPLUG data are available.
When you have selected "Probe", you must enter the interior diameter of the surrounding
tube in "Diameter".
8.7

Function Group Service

Enter Code (menu item 6.1)
You can disable the control and display unit with a personal, freely selectable code number to
prevent programming of the device by unauthorized persons. By entering the appropriate code
number in this menu item, the programming is enabled and you can change the device settings.
• Factory set code "0"
• Customer code (see menu item 6.2 "Code change")
Note
If you actuate one of the
are automatically prompted to enter the code in the device display. The programming is
disabled after returning to the display mode. The programming can also be disabled by
entering any number which does not match the actual customer code in this menu item.
After input of '3333' the fixed personal code is briefly displayed (help function as reminder).
Customer code (Menu item 6.2)
You can change the personal code number in this menu item.
The code is factory set to 0. The menu item is only accessible after entering the personal code
even when programming has already been enabled.
Note
Programming is always enabled when the code = 0.
Service code (Menu item 6.3)
The calibration data of the device are protected by a special code (factory code). The appropriate
menu items are only available after entering this factory code.
Reset (Menu item 6.4)
Here you can perform a "warm start" of the controller.
This retains all saved units, but the volume totalizer is reset to zero.
TRANSMAG 2 with MAG 911/E
Operating Instructions, 03/2021, A5E00102775-AC
or
operating elements in the setting level of the parameter, you
Functions
8.7 Function Group Service
73

Advertisement

Table of Contents
loading

Table of Contents