Saving System Data - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

6

Saving system data

Saving data
This function saves the NC and PLC data of the volatile memory into a non-volatile memory area.
Prerequisite:
● A valid system password has been set on the control system.
● There is no program currently executing.
Proceed through the following steps to save data:
1.
+
2.
3.
There are two methods to call the saved data.
Method 1:
1.
2.
3.
Method 2:
1.
+
2.
3.
4.
5.
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014
Select the desired operating area.
Open the window for data saving.
Press this softkey to start saving. Do not carry out any operator actions while the data
backup is running.
Press this key when the control system is booting.
Select "Reload saved user data" in the setup menu.
Press this key to confirm.
Select the desired operating area.
Open the window for selecting the start up modes.
Select this softkey.
Use the cursor keys to select the third start up mode.
Press this softkey to confirm. The control system restarts with the saved data.
47