7.
8.
Parameters for face milling
①
Tool number
②
Cutting edge number
③
Work offset to be activated
④
Retraction plane
⑤
Safety distance
⑥
Path feedrate
⑦
Spindle speed
A.8.3
Setting the JOG data
Operating sequence
1.
2.
3.
4.
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014
Use this softkey to confirm your settings. The system now automatically creates the part program.
Press this key on the MCP to run the part program.
Select the desired operating area.
Switch to "JOG" mode.
Press this horizontal softkey to open the following window:
Enter values in the input fields and confirm your entries.
⑧
Direction of spindle rotation
⑨
Machining type selection: roughing or finishing
⑩
X\Y\Z position of the blank
⑪
Cutting dimension in the X\Y\Z direction, specified in
increments
⑫
Cutting length in the X\Y\Z direction, specified in
increments relative to the workpiece edge
⑬
Stock allowance in the Z direction
229