Deep-Hole Drilling - Cycle83 - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

N10 G0 G17 G90 F200 S300 M3
N20 D1 T10 Z110
N30 X24 Y15
N40 CYCLE82 (110, 102, 4, 75, , 2)
N50 M02
Programming example2: Drilling_counterboring
Proceed through the following steps:
1.
2.
3.
4.
5.
9.4.5

Deep-hole drilling - CYCLE83

Programming
CYCLE83 (RTP, RFP, SDIS, DP, DPR, FDEP, FDPR, DAM, DTB, DTS, FRF, VARI, AXN, MDEP, VRT, DTD, DIS1)
Parameters
Parameter Data type
RTP REAL
RFP REAL
SDIS REAL
DP REAL
DPR REAL
130
Select the desired operating area.
Open the vertical softkey bar for available drilling cycles.
Press this softkey from the vertical softkey bar.
Press this softkey to open the window for CYCLE82. Parameterize the cycle as desired.
Confirm your settings with this softkey. The cycle is then automatically transferred to the program
editor as a separate block.
Description
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Final drilling depth (absolute)
Final drilling depth relative to the reference plane (enter without sign)
; Specification of technology values
; Approach retraction plane
; Approach drilling position
; Cycle call with absolute final drilling
depth and safety clearance
; End of program
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014