Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual page 251

3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014
Select a program with cursor keys and press the following key to open the program in the program
editor.
Press this softkey to open the contour editor.
Define a start point with the following parameters and press this softkey to confirm.
● Programming plane: G17
● X: 0
● Y: 0
Press this softkey to select a contour element of straight vertical line.
Enter the parameters for this element and press this softkey to confirm.
● Y: -104 abs.
Press this softkey to select a contour element of circular arc.
Enter the parameters for this element and press this softkey to select the desired contour
characteristics.
● Direction of rotation: clockwise
● R: 79
● I: 0 abs.
● β2: 30 °
Press this softkey to confirm.
Press this softkey to select a contour element of circular arc.
Enter the parameters for this element and press this softkey to select the desired contour
characteristics.
● Direction of rotation: clockwise
● R: 7.5
● β2: 180 °
Press this softkey to confirm.
Press this softkey to select a contour element of circular arc.
251