Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual page 224

Parameters in the window for timers and workpiece counters
① The total number of workpieces produced (total
actual)
②
The number of workpieces required (workpiece
setpoint)
③ The number of all workpieces produced since the
starting time
④
The total run time of NC programs in "AUTO" mode
and the run time of all programs between NC start
and end of program/RESET. The timer is set to
zero with each power-up of the control system.
Note: The timer is automatically reset to zero in case of a control power-up with default values.
Modifying miscellaneous setting data
Operating sequence
1.
2.
3.
4.
224
Select the desired operating area.
Open the setting data window.
Open the window for miscellaneous setting data.
Select a group of setting data you desire to modify.
⑤ The run time of the selected NC program in seconds
The default value is 0 each time a new NC program
starts up. MD27860 can be set to ensure that this value
will be deleted even if there is a jump to the beginning of
the program with GOTOS or in the event of ASUBS
(used for tool change in "JOG" and "MM+" modes) and
PROG_EVENTs starting.
⑥
Processing time in seconds
⑦ The time since the last control power up with default
values ("cold restart") in minutes
⑧
The time since the last normal control power up ("warm
restart") in minutes
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014