Use Quick Connect Via A Rear Ethernet Port; Set Up Cybersentry And Change Default Password - GE C30 Instruction Manual
Controller system
Hide thumbs
Also See for C30:
- Instruction manual (488 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (342 pages)
Table of Contents
Advertisement
SET UP CYBERSENTRY AND CHANGE DEFAULT PASSWORD
3
5.
Select the serial Interface and the communications port (COM Port) from the drop-down lists, then click Connect. The
COM Port is that of the computer.
6.
The EnerVista software creates a site named "Quick Connect" with a corresponding device also named "Quick
Connect" and displays them in the Online Window. Expand the sections to view data directly from the UR device. Use
the Device Setup button to change the site name.
Each time that the EnerVista UR Setup software is initialized, click the Quick Connect button to establish direct
communications to the C30. This ensures that configuration of the EnerVista UR Setup software matches the C30 model
number.
3.8.3 Use Quick Connect via a rear Ethernet port
To connect to a UR using an Ethernet cable:
1.
In the EnerVista software, click the Quick Connect button. The window opens.
2.
Select the Ethernet interface and enter the IP address assigned to the C30, then click the Connect button. The
EnerVista UR Setup software creates a site named "Quick Connect" with a corresponding device also named "Quick
Connect" and displays them in the Online Window.
3.
Expand the sections to view data directly from the C30 device. Use the Device Setup button to change the site name.
Each time that the EnerVista software is initialized, click the Quick Connect button to establish direct communications to
the C30. This ensures that configuration of the EnerVista UR Setup software matches the C30 model number.
3.9 Set up CyberSentry and change default password
If and when first using CyberSentry security, use the following procedure for set up.
1.
Log in to the relay as Administrator by using the
(so that no IP address is required). If logging in through EnerVista choose Device authentication. Enter the default
3-58
Figure 3-59: Quick Connect window to access a device
keys on the front panel or through EnerVista connected serially
VALUE
CHAPTER 3: INSTALLATION
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
Advertisement
Table of Contents
