PRODUCT SETUP
Clearing records with user-programmable operands is not protected by the command password. However, user-
programmable pushbuttons are protected by the command password. Thus, if they are used to clear records, the user-
programmable pushbuttons can provide extra security if required.
For example, to assign user-programmable pushbutton 1 to clear demand records, apply the following settings.
1.
Assign the clear demand function to pushbutton 1 by making the following change in the
CLEAR RELAY RECORDS
CLEAR DEMAND
2.
Set the properties for user-programmable pushbutton 1 by making the following changes in the
SETUP USER-PROGRAMMABLE PUSHBUTTONS USER PUSHBUTTON 1
PUSHBUTTON 1 FUNCTION
PUSHBTN 1 DROP-OUT TIME
5.3.4 Communications
5.3.4.1 Menu
SETTINGS PRODUCT SETUP COMMUNICATIONS
COMMUNICATIONS
5
5.3.4.2 Serial ports
SETTINGS PRODUCT SETUP COMMUNICATIONS SERIAL PORTS
SERIAL PORTS
5-24
menu:
: "
"
PUSHBUTTON 1 ON
: "Self-reset"
: "0.20 s"
SERIAL PORTS
NETWORK
IPv4 ROUTE TABLE
MODBUS PROTOCOL
PROTOCOL
DNP PROTOCOL
DNP / IEC104
POINT LISTS
IEC 61850 PROTOCOL
WEB SERVER
HTTP PROTOCOL
TFTP PROTOCOL
IEC 60870-5-104
PROTOCOL
EGD PROTOCOL
IEC103
PROTOCOL
RS232 BAUD
RATE: 115200
CHAPTER 5: SETTINGS
SETTINGS PRODUCT SETUP
SETTINGS PRODUCT
menu:
See below
See page 5-27
See page 5-30
See page 5-33
See page 5-33
See page 5-34
See page 5-38
Access in EnerVista
See page 5-39
See page 5-80
See page 5-81
See page 5-81
See page 5-83
See page 5-84
Range: 19200, 115200
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL