RECORDS
6.4.3 Transducer inputs and outputs
ACTUAL VALUES METERING TRANSDUCER I/O DCMA INPUTS DCMA INPUT xx
DCMA INPUT xx
Actual values for each DCmA input channel that is enabled are displayed with the top line as the programmed channel ID
and the bottom line as the value followed by the programmed units.
ACTUAL VALUES METERING TRANSDUCER I/O RTD INPUTS RTD INPUT xx
RTD INPUT xx
Actual values for each RTD input channel that is enabled are displayed with the top line as the programmed channel ID
and the bottom line as the value.
6.5 Records
6.5.1 Event records
ACTUAL VALUES RECORDS EVENT RECORDS
EVENT RECORDS
6
The event records menu shows the contextual data associated with up to the last 1024 events, listed in chronological
order from most recent to oldest. When all 1024 event records have been filled, the oldest record is removed as a new
record is added. Each event record shows the event identifier/sequence number, cause, and date/time stamp associated
with the event trigger. See the
Only major output operands generate events, not every operand. Elements that assert output per phase, for example, log
operating phase output only without asserting the common three-phase operand event.
See also the system log (syslog) information in the previous chapter.
The event records are also viewable in the software and in a web browser. The figure shows the event records in the
software. To view them in a web browser, enter the IP address of the device.
6-12
DCMA INPUT xx
0.000 mA
RTD INPUT xx
-50 °C
EVENT: XXX
XXX
EVENT: 3
POWER ON
EVENT: 2
POWER OFF
EVENT: 1
EVENTS CLEARED
COMMANDS
CLEAR RECORDS
Date and time stamps
EVENT 3
DATE: 2000/07/14
EVENT 3
TIME: 14:53:00.03405
menu for clearing event records.
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: ACTUAL VALUES