FLEXLOGIC DESIGN AND MONITORING USING ENGINEER
22.214.171.124 Advanced Actions toolbar
Only basic objects (lines, rectangles, ellipses) can be rotated and flipped.
Only objects from the Drawing Toolbar can be structured (grouped, ungrouped, forward, backward).
Set the width and height of the selected components to the same width and height of
the reference component
Nudge Up, Down, Left, Right
Moves selected component one pixel upward, downward, left, right
Rotates selected component freely. Once selected, put your mouse cursor over the
component and move the component clockwise or counter-clockwise depending on
what you need.
Rotate Left, Right
Rotates selected component 90 degrees counter-clockwise or clockwise
Flips the selected component on the vertical axis
Flips the selected component on the horizontal axis
Combines all selected components into one combined entity. Ungroups them into
Moves current components to the absolute front or back of all viewable layers
Moves current components on layer higher or lower than its original layer hierarchy
CHAPTER 4: INTERFACES
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL