Configure The Built-In Ethernet Port Of The Cpu; Figure 21: Include Actv_Csb In Input Transfer List; Figure 22: Assign Ethernet Status Address - GE PACSystems RX3i Application Manual

Chapter 5. PLC Hardware Configuration (Primary PLC)
Optionally, there is one symbolic variable that may be included in the synchronized data transfer list. It is
located in the program logic block named AUTO_SW. The variable ACTV_CSB must be included in the Input
Transfer List if you wish to perform automatic role switches based upon the loss of devices on a GCG.

Figure 21: Include ACTV_CSB in Input Transfer List

5.3

Configure the Built-in Ethernet Port of the CPU

The RX3i CPU includes two built-in Ethernet ports that share an 80-bit diagnostic/status reference. The
recommended starting reference is %I16385.

Figure 22: Assign Ethernet Status Address

Note that there are additional port settings for LAN1 and LAN2. These will require configuration entries as well.
24 PACSystems* RX3i Genius Dual Bus Application Guide GFK-2928