GE C30 Instruction Manual page 172

PRODUCT SETUP
Setting name
Firmware Lock
(via Lock Relay)
Factory Service
Mode
Restore to Defaults Sets the device to factory defaults
Supervisor Role
RADIUS user names Ensures that RADIUS user names are not the
Password
5
Table 5-5: Security alarm settings
Setting name
Failed
Authentications
Firmware Lock
Settings Lock
CyberSentry settings through the front panel
SETTINGS  PRODUCT SETUP  SECURITY
 SECURITY

5-16
Description
Indicates if the device receives firmware
upgrades. If Enabled and the firmware
upgrade attempt is made, the device denies
the upgrade and displays an error message
that the lock is set. On each firmware upgrade,
this setting goes back to the default.
The Lock Relay setting blocks settings and
firmware updates.
When enabled, the device can go into factory
service mode. To enable, Supervisor
authentication is necessary.
When enabled, the Supervisor role is active. To
enable, Administrator authentication is
necessary. When disabled, the Supervisor role
is inactive. To disable, Supervisor
authentication is necessary.
same as local/device role names
Local/device roles except for Observer are
password-protected. All RADIUS users are
password-protected.
Description / Details
A threshold number indicating when an alarm
is set off to indicate too many failed
authentication attempts
A value indicating if the device can receive a
firmware upgrade. If Enabled and a firmware
upgrade attempt is made, the device alarm
activates. If Disabled, the device alarm does not
activate. On each firmware upgrade this setting
goes back to the default.
A value indicating if the device can accept any
settings changes. If Enabled and a settings
change attempt is made, the device alarm
activates. If Disabled, the device alarm does not
activate.
LOGIN:

None
 CHANGE LOCAL

 PASSWORDS
 SESSION

 SETTINGS
Minimum Maximum Default
Disabled Enabled Enabled
Disabled Enabled Disabled
No Yes No
Disabled Enabled Enabled
See RADIUS See
server RADIUS
documents server
document
s
See the See the Change
Password following Me1#
Requirements password
section earlier section for
in this chapter requireme
nts
Min Max Default
0 99 3
(disabled)
Disabled Enabled Enabled
Disabled Enabled Enabled
Range: Administrator, Engineer, Supervisor,
Operator, Factory (for factory use only), None
See page 5-17
See page 5-18
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
Units Minimum
permission
- Administrator
- Supervisor
(Administrator
when Supervisor
is disabled)
- Administrator
- Administrator to
enable and
Supervisor to
disable
- Administrator
Text The specified
role and
Administrator,
except for
Supervisor,
where it is only
itself
Units Minimum
permissions
- Administrator
- Administrator
- Supervisor
(Administrator if
Supervisor has
been disabled)