GE C30 Instruction Manual page 142

FLEXLOGIC DESIGN AND MONITORING USING ENGINEER
4.4.1.6 Connect two logic diagrams
When the logic is complex and requires two sheets, for example, these two sheets can be connected. By connecting them,
the logic is continuous from one sheet to the next.
To connect two logic diagrams:
1. In the first sheet, click the I/O Tokens tab.
2. Scroll to the bottom, and click and drag the Tag Out element to the sheet where the next sheet is to connect.
3. Double-click the element and in the window that opens, give it a name, such as "To Sheet 2" or "To IO Sheet 2."
4
4. In the second sheet, click and drag the Tag In element to the sheet where the first sheet is to connect.
5. Double-click the element and in the window that opens, select the first sheet from the drop-down list to connect the
two sheets.
6. Save the work.
4.4.1.7 Optimize the logic
The number of available FlexLogic entries depends on firmware, for example 515 or 1024 lines. The software can
automatically optimize a logic diagram to reduce space and free up entries.
To optimize the logic:
1. In Engineer, under File > Preferences, select the Compiler option. Ensure that the Optimize Compiled Output option is
enabled.
2. Run the compiler again, for example by clicking the Compile button at the bottom left of the software. The results
display in the Optimization Summary. Changes also display when the FlexLogic Equation Editor is accessed. The logic
diagram does not change. In the example shown, no lines were saved to free up space.
4-42
Figure 4-43: Connecting sheet 1 to sheet 2
Figure 4-44: Code optimization results
CHAPTER 4: INTERFACES
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL