Engaging Reverse (Rer) (E-Tec) - Lynx Rave 600 ACE 2017 Operator's Manual

BASIC PROCEDURES
CAUTION Beware of injuries
by using proper lifting techniques,
notably using your legs force. Do
not attempt to lift the rear of vehicle
if it is above your limits.
WARNING
Make sure tether cord cap is re-
moved before standing in front the
vehicle, getting close to the track
or rear suspension components.
NOTE: On E-TEC models, warm-up is
electronically controlled. During this
period (up to 10 minutes depending on
ambient temperature), engine RPM is
limited.
Engaging Reverse (RER)
(E-TEC)
When the engine is running, depress-
ing the RER button will slow down
engine RPM to almost a stop and ad-
vance the ignition timing to cause di-
rection change in crankshaft rotation.
– Engine will automatically shift into
forward when re-starting after stop-
ping or stalling.
– Shifting procedure will take place
only when the engine is running.
– If engine is running at a speed above
4300 RPM, the reverse function of
the RER button is cancelled.
– It is recommended to warm up the
engine to its normal operating tem-
perature before shifting.
Shifting in Reverse
1. Bring vehicle to a complete stop.
2. Apply and hold brake. Remain
seated, refer to
(REVERSE OPERATION)
ture information.
3. With engine at idle speed, press and
release the RER button.
4. Wait until reverse beeper sounds,
then gently depress throttle lever.
______________
90
RIDER POSITION
for pos-
WARNING
Engaging the reverse mode is
done by depressing the RER
button when the engine is run-
ning. Wait until the reverse alarm
sounds and the RER pilot lamp
comes on in the analog/digital
gauge before operating throttle
to proceed in reverse. The reverse
speed is not limited. Always pro-
ceed with caution as fast reverse
could result in loss of vehicle sta-
bility. Come to complete stop be-
fore depressing RER button. Al-
ways remain seated and apply the
brake before shifting. Ensure the
path behind is clear of obstacles or
bystanders before proceeding.
WARNING
Shifting in Forward
1. Bring vehicle to a complete stop.
2. Apply and hold brake.
3. Press and release the RER button.
RER pilot lamp will stop.
4. RER pilot lamp will stop.
5. Apply throttle slowly and evenly. Al-
low drive pulley to engage then ac-
celerate carefully.