Lynx Rave 600 ACE 2017 Operator's Manual page 129

Drive Belt Installation
1. If necessary, open the driven pulley,
DRIVE BELT REMOVAL
refer to
2. Slip the belt over the drive pulley,
then over the driven pulley.
NOTICE
Do not force or use tools
to pry the belt into place, as this
could cut or break the cords in the
belt.
NOTE: The maximum drive belt life
span is obtained when belt is installed
with arrows in the direction of rotation.
mmo2011-002-006_a
1. To be pointed in the direction of rotation
3. Unscrew and remove the driven pul-
ley expander from the pulley.
4. Rotate the driven pulley several
times to properly set the belt be-
tween the sheaves.
5. If a new belt was installed, adjust
the belt height. Refer to
BELT HEIGHT ADJUSTMENT
low.
6. Install belt guard, refer to
BELT GUARD
CONTROLS/INSTRU-
section in
MENTS/EQUIPMENT
7. Close side panel, refer to
AND SIDE PANELS
TROLS/INSTRUMENTS/EQUIP-
MENT
.
Drive Belt Height Adjustment
The drive belt height must be checked
every time a new belt is installed.
To adjust the drive belt height, proceed
as follows:
1. Remove D.E.S.S. key frompost.
.
DRIVE
be-
DRIVE
INSTALLATION
.
HOOD
CON-
section in
______________
MAINTENANCE PROCEDURES
2. Open LH side panel, refer to
AND SIDE PANELS
TROLS/INSTRUMENTS/EQUIP-
MENT
.
3. Remove belt
DRIVE BELT GUARD REMOVAL
CONTROLS/INSTRU-
section in
MENTS/EQUIPMENT
4. Loosen the clamping bolt.
mmo2011-003-010_a
ALUMINUM ADJUSTER HUB
1. Adjuster hub
2. Clamping bolt
5. Using the suspension adjustment
tool provided in the tool kit, turn the
ring 1/4 turn at a time then rotate the
driven pulley to properly set the belt
between the pulley sheaves.
mmo2011-003-011_a
ALUMINUM ADJUSTER HUB
1. Suspension adjustment tool
NOTE: The adjustment ring has left
hand treads
HOOD
CON-
section in
guard, refer to
.
127