Lynx Rave 600 ACE 2017 Operator's Manual page 176

MONITORING SYSTEM
NOTE: Some of the listed pilot lamps and messages do not apply to all models.
The message display is available only on the multifunction analog/digital gauge.
PILOT
LAMP(S) BEEPER
ON
4 short
beeps every
5 minutes
4 short
beeps every
30 seconds
Short beeps
repeating
rapidly
4 short
beeps every
5 minutes
4 short
beeps
______________
174
MESSAGE
DISPLAY
LOW OIL
ENGINE
OVERHEAT
MUFFLER
ENGINE
OVERHEAT
MUFFLER
OVERHEAT
ECM OVERHEAT
LOW BAT
HIGH BAT
CHECK ENGINE
DESCRIPTION
E-TEC: Injection oil level is low. Stop
vehicle in a safe place then, replenish
injection oil reservoir.
ACE: Low engine oil pressure. Stop
vehicle in a safe place then, check oil
level. Fill to proper level. If oil level was
correct, discontinue use and contact an
authorized Lynx dealer.
Engine is overheating,
snowmobile speed and run in loose
snow or stop engine immediately and
let engine cool down. Check coolant
level, refer to MAINTENANCE
level is correct and overheating persists,
contact an authorized Lynx dealer. Do
not run the engine if condition persists.
Reduce speed or stop engine. Let engine
cool down and restart. If overheating
persists, contact an authorized Lynx
dealer. Do not run the engine if condition
persists.
Critical overheat.
immediately and
down. Check coolant level, refer to
MAINTENANCE
. If coolant level is
correct and overheating persists, contact
an authorized Lynx dealer. Do not run the
engine if condition persists.
E-TEC: Critical overheat. Stop engine
immediately and let engine cool down.
If overheating persists,
authorized Lynx dealer. Do not run the
engine if condition persists. Do not run
the engine if condition persists.
Indicate a low or high battery voltage
condition. See an authorized Lynx dealer
as soon as possible.
Engine fault, see an authorized Lynx
dealer as soon as possible.
reduce
. If coolant
Stop engine
let engine cool
contact an