Lynx Rave 600 ACE 2017 Operator's Manual page 131

ENGINE
HORSEPOWER RPM
600 HO E-TEC
800 R E-TEC
NOTE: Use precision digital tachome-
ter for engine RPM adjustment.
NOTE: The adjustment has an effect
on high RPM only.
There are 6 positions numbered 1 to 6.
The calibration screws have 6 different
settings identified by numbers scribed
on their head.
The actual setting is the screw head
number aligned with the mark on the
pulley.
mmo2011-002-101_a
PULLEY SETTING
1. Mark
2. Number
Each position modifies maximum en-
gine RPM by about 200 RPM.
Lower position numbers decrease en-
gine RPM in steps of 200 RPM and
higher position numbers increase it in
steps of 200 RPM.
Example:
Calibration screws initially set at posi-
tion 4 and changed to position 6 will
increase maximum engine RPM by
400 RPM.
MAXIMUM
8100 RPM (± 100)
7900 RPM (± 100)
______________
MAINTENANCE PROCEDURES
Procedure
Loosen the lock nut just enough to get
the calibration screw head out of the
pulley and rotate to the desired posi-
tion. Do not completely remove the
lock nut.
Set all 3 calibration screws to the same
position.
Tighten lock nuts to the specified
torque.
TIGHTENING TORQUE
Lock nuts
NOTICE
Do not completely re-
move calibration screw otherwise
internal washers will fall off. Al-
ways adjust all 3 calibration screws
and make sure they are all set to the
same position.
mmo2015-007-303_a
TYPICAL
1. Loosen just enough to permit rotating of
calibrate screw
10 N•m ± 2 N•m
(89 lbf•in ± 18 lbf•in)
129