Lynx Rave 600 ACE 2017 Operator's Manual page 177

PILOT
LAMP(S) BEEPER
ON
—
4 short
—
beeps every
5 minutes
4 short
—
beeps every
5 minutes
— —
Short beeps
—
repeating
rapidly
— —
2 short
beeps
2 short
beeps,
repeating
DESS
slowly
Short beeps
repeating
rapidly
MESSAGE
DISPLAY
KNOCK
REV LIMIT
OVER REV
SHUTDOWN
COMMUNICATION
—
CHECK KEY
BAD KEY
______________
DESCRIPTION
Displayed when brake is applied for more
than 15 seconds while throttle lever is
squeezed and vehicle is moving at more
than 5 km/h (3 MPH).
E-TEC: Engine detonation (RPM is limited
when this condition occurs).
– Ensure recommended fuel is used.
– Check fuel quality, replace if
necessary.
– If fault still occurs, contact an
authorized Lynx dealer.
Engine RPM limited for protection when
certain faults occur.
On E-TEC engines,
maximum engine RPM is reached.
Check clutch calibration.
Shutdown procedure
to engine overheating or fuel pump
problem, remove tether cord cap from
engine cut-off switch and contact an
authorized Lynx dealer.
Communication problem between ECM
and gauge. Stop engine, remove tether
cord cap. Wait a few minutes, then start
engine. If problem persists, contact an
authorized Lynx dealer.
Good key, vehicle ready to operate.
Unable to read key (bad connection).
Make sure the key is clean and correctly
snapped on post.
Invalid key or key not programmed. Use
the proper key for the vehicle or have the
programmed.
MONITORING SYSTEM
indicates that
in force due
175