T9 Analog Output 1 Source; T9 Analog Output 1 Scaling; T9 Analog Output 1 Mode; T10 Analog Output 2 Source/T10 Analog Output 2 Scaling - Emerson Mentor MP Advanced User's Manual

Parameter Keypad and
structure
7.19

T9 analog output 1 source

Bit SP
Coding
Range Pr 0.00 to Pr 22.99
Default Pr 3.02 = {di05, 0.40}
Update rate Read on drive reset
7.20

T9 analog output 1 scaling

Bit SP
Coding
Range 0.000 to 40.000
Default 1.000
Update rate Background read
7.21

T9 analog output 1 mode

Bit SP
Coding
Range 0 to 3
Default 0
Update rate Background read
The following modes are available for the analog outputs.
Parameter value Parameter string
0
1
2
3
If high-speed update mode is selected and the source for the output is one of the parameters designated for high-speed analog output operation (see
start of this section) the output is updated at a higher rate with special scaling. If the parameter selected is not designated for this mode the output is
updated at the normal rate. If speed feedback is selected for high-speed mode for both analog output 1 and analog output 2 the setting is ignored for
analog output 2. If the high-speed mode is selected the output is always a voltage signal.
7.22 T10 analog output 2 source
Bit SP
Coding
Range Pr 0.00 to Pr 22.99
Default Pr 4.02
Update rate Read on drive reset
7.23 T10 analog output 2 scaling
Bit SP
Coding
Range 0.000 to 40.000
Default 1.000
Update rate Background read
Mentor MP Advanced User Guide
Issue Number: 4
format
Parameter description
FI DE TE VM DP ND
2
FI DE TE VM DP ND
3
FI DE TE VM DP ND
1
Mode
VOLt Voltage mode
0-20 0 - 20 mA
4-20 4 - 20 mA
H.Spd High speed up date mode
FI DE TE VM DP ND
2
FI DE TE VM DP ND RA
3
www.onxcontrol.com
Advanced parameter
descriptions
RA NC NV PT US RW BU
1 1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1 1
NC NV PT US RW BU
1 1
Serial comms
Performance
protocol
PS
1
PS
1
PS
1
PS
1
PS
1
Menu 7
113