Master / Slave Control Connections For 24 Pulse; Pulse Parallel Operation 2 Drives - Emerson Mentor MP Advanced User's Manual

Parameter
Menu 5
structure
Figure 5-9 Master / Slave control connections for 24 pulse
Master drive
1 9
21 2425 2829
Auto Tune procedure
1. Set Pr 5.25 = 1 on Slave drives.
2. Set Pr 5.12 = 1 on Master drive.
3. Enable the system. When auto tune has finished, transfer the values of Pr 5.15, Pr 4.13, Pr 4.14 and Pr 4.34 from the master to each of the slave
drives.
4. Re start auto tune by setting Pr 5.12 to 1 on the master drive only.
5. Enable the system.
6. When auto tune has finished, transfer the values of Pr 5.15, Pr 4.13, Pr 4.14 and Pr 4.34 from the master to the slave.
7. Set Pr 5.25 = 0 on Slave drives
Auto tune is now complete.
Figure 5-10 6 Pulse parallel operation 2 drives
L3
L2
L1
Choke / inductor
Master drive
A1
A2
*For fuse information please refer to section 4.6 in the Mentor MP User Guide.
82
Keypad and
Parameter x.00
Slave drive
11 1 7
31 21 2425 2829
Fuses*
Slave drive
RJ 45
www.onxcontrol.com
Advanced parameter
description format
descriptions
Parameter
Slave drive
11 1 7
31 21 2425 2829
RJ 45
Serial comms
Performance
protocol
Slave drive
11 1 7
21 2425
Mentor MP Advanced User Guide
Issue Number: 4
11
2829 31