Self-Adhesive Labels - Intermec EasyCoder E4 Installation & Operation Manual

Paper, cont'd.

Self-Adhesive Labels

Self-Adhesive
Labels
Label Stop
Sensor
position
Paper feed
direction
Intermec EasyCoder E4 LinerLess – Installation & Operation Ed. 1
⇐ a ⇒ Web Width (including backing paper):
Maximum ................................ :
Minimum ................................ :
⇐ b ⇒ Backing Paper
The backing paper must not extend more than a total of 1.6 mm
(0.06") outside the paper and should protrude equally on both side.
Minimum transparency: 40% (DIN 53147).
⇐ c ⇒ Label Width (excluding backing paper):
Maximum ................................ :
Minimum ................................ :
⇐ d ⇒ Label Length:
Minimum ................................ :
⇐ e ⇒ Label Gap:
Maximum ................................ :
Recommended: ........................ :
Minimum ................................ :
The Label Stop Sensor must be able to detect the extreme front and
rear edges of the labels. It is positioned 12 mm from the left edge of
the media, so do not use labels with a large inner corner radius.
Media type setup:
• Label (w gaps)
Appendix 2 Media Specifications
114.0 mm (4.5")
25.4 mm (1.00")
112.4 mm (4.44")
23.8 mm (0.94")
10 mm 0.39")
10.0 mm (0.39")
1.6 mm (0.06")
1.2 mm (0.05")
59