Intermec EasyCoder E4 Installation & Operation Manual page 23

Chapter 4 Programming
Command List, cont'd.
Instruction
BARRATIO (BR)
BARSET
BARTYPE (BT)
BREAK
BREAK ON/OFF
CHR$
CLEANFEED
CLL
COPY
COUNT&
22
Purpose and Syntax
Specifies the width ratio between wide and narrow bars in a bar code.
BARRATIO|BR <ratio>
Specifies a bar code and sets additional parameters for complex bar codes.
BARSET [#<start parameter>,]"bar code name",<ratio wide bars>,
<ratio narrow bars>,<mag>,<height>
Specifies the type of bar code.
BARTYPE|BT "<bar code name>"
Specifies a break interrupt character separately for the parallel and serial
communication channels.
BREAK <device>,<break character>
Enables/disables break interrupt separately for the parallel and serial
communication channels.
BREAK <device> ON|OFF
Returns the ASCII character whose number is given in the brackets.
CHR$(<ASCII character number>)
Runs the printer's feed mechanism, for the distance specified in dots to
allow cleaning.
CLEANFEED <length in dots>
Completely clears the print image buffer, if no starting field is specified.
If a field is specified, the print image buffer is cleared from the field to the
end of the label.
CLL [<variable name>%]
Copies files.
COPY "[<source device>]<original filename>",
"[destination device>]<new filename>"|"uart1:"
Creates a counter. Alpha counters range from A to Z, but numeric
counters have no practical limit.
COUNT& "START",<counter number>,"<start value>"
COUNT& "WIDTH",<counter number>,"<number of digits>"
COUNT& "COPY",<counter number>,"<number of copies>"
COUNT& "INC",<counter number>,"<incr. value>|<decr. value>"
COUNT& "STOP",<counter number>,"<stop value>"
COUNT& "RESTART",<counter number>,"<restart value>"
Intermec EasyCoder E4 LinerLess – Installation & Operation Ed. 1