Intermec EasyCoder E4 Installation & Operation Manual page 28

Command List, cont'd.
Instruction
REMOVE IMAGE
SETSTDIO
SETUP
SETUP WRITE
SYSVAR
TESTFEED
TIME$
TIMEADD$
V% = FIELDNO
VERSION$
WEEKDAY$
WEEKNUMBER
Intermec EasyCoder E4 LinerLess – Installation & Operation Ed. 1
Purpose and Syntax
Removes a specified image from the printer's memory.
REMOVE IMAGE "<name>"
Forces selection of standard IN and OUT communication channel. This
is normally automatic.
SETSTDIO <IN channel>,<OUT channel>
Changes the setup by means of a setup string or setup file.
SETUP "<setup string>"|"<setup filename>"
Creates a setup file containing the printer's current setup values or prints
the current setup to the host via the serial port.
SETUP WRITE "<setup filename>"|"uart1:"
Reads or sets various system variables.
PRINT SYSVAR(<parameter>)
SYSVAR(<parameter>)=<value>
Slowly feeds paper to allow the label stop sensor to adjust itself according
to the presently loaded paper web.
TESTFEED
Sets or returns the current time, optionally in the format specified by the
FORMAT TIME$ command.
TIME$ = "<HHMMSS>"
PRINT TIME$[("F")]
Returns a new time after a number of seconds have been added to, or
subtracted from, the current time or optionally a specified time.
PRINT TIMEADD$(["<original time>",]<no. of seconds>[,"F"])
Assigns the number of the current field to a variable.
<variable name>%=FIELDNO
Returns the version of the software, printer family, or type of CPU board.
PRINT VERSION$[(<type of info>)]
Returns the name of the weekday for a specified date.
PRINT WEEKDAY$("<date>")
Returns the number of the week for a specified date.
PRINT WEEKNUMBER("<date>")
Chapter 4 Programming
27