Machine Electrical Connection - GIRBAU HS-6013 Installation Instructions Manual

Safety switch. Install an Automatic on/off Switch, outside the washer, with individual protection for each
machine.
Characteristics:

number of poles and intensity: consult ELECTRICAL CONNECTION table (section 1.5)

C type with top opening greater than 0.12 in (3 mm)

must isolate electrical source phases and the N cable.

mechanically lockable.

installed in an easily accessible place.
CAUTION !
In machines with ETL mark, the SAFETY SWITCH must be UL489 approved.

3.3.3. Machine electrical connection

 Disconnect and mechanically lock the external automatic switch.
 Open machine terminal box at the rear panel. Remove the support cover of the entry switch to the washer.
 On the entry hole of the electrical supply (E identified in figure 2) install a lock mechanism (not supplied with
the washer) to fasten the cable or cable pipe protector, depending on the cable and pipe protector used.
Refer to dimensions and connection diameter in INSTALLATION SPECS, section 1.4.
 Connect the wires directly to the switch breaker.
 The wire connection sequence to the main switch
varies according to the machine connection and the
power supply. This connection is indicated on the
label posted next to the main switch.
 In models HS-6024 and EH060, pass the conductor
through the cable tie (A) and secure it as shown in
Fig.3.6.
FOR A CORRECT CONNECTION, FOLLOW THE INDICATIONS OF THE SECTIONS BELOW
LABEL
SUPPLY
LINE
HS/EH
CONNECTION
Installation
PE/GND PE/GND
L1
L2/N
L1
L2
PE/GND
L1 L1
L2/N L2
L3
L1 L1
N L2
L3
30
Fig. 3.6
PE/GND
L1
L2
L3
N
L1
L2
L3
N
Cod.nº 429043
Rev. 15/1215