Hs-6023, Eh055 Models - GIRBAU HS-6013 Installation Instructions Manual

2.6.2. HS-6023, EH055 models


Remove the screws (Fig.2.7/A) holding the lower front cover and loosen the three screws (Fig. 2.7/B)
holding the base of the chassis.

Separate the rubber profile (Fig. 2.7/C) at the two small side guards and remove the front cover
(Fig. 2.7).

Remove the screws holding the rear cover and remove it.

Locate on the chassis base the two yellow fixing profiles and dismantle them. The profiles are secured
with screws (Fig. 2.8).

Assemble the rear cover.

Assemble the front cover and place the rubber profile at the small side guards.
CAUTION!
The rubber profile is a protection against cutting and catching. Check that it is properly fixed on the
front cover and side covers.

Assemble the toe plate (Fig. 2.9). This
piece is shipped disassembled from the
machine.

Fit the perforated metal plate onto the
lower aperture at the back of the machine.

Both protections
dismantled from the rest of the machine,
and the securing screws are screwed into
the respective securing points.
Transport and location
Fig. 2.7
are dispatched
25
Fig. 2.8
Fig. 2.9
Cod.nº 429043
Rev. 15/1215