NAC Image Technology SP-642 User Manual page 95

MULTI1(C)
MULTI2(A)
MULTI2(C)
MULTI3(A)
MULTI3(C)
LINEAR
Trigger Timing
START
CENTER
END
BURST
CUSTOM
Shutter
OPEN
2k
5k
5k
10k
20k
50k
100k
200k
CUSTOM
Low Light
OFF
100pps
250pps
500pps
1000pps
CUSTOM
Sensor Gain
AOI
Image Trigger
(00292)H
Refer to page 4-63.
Refer to page 4-63.
Refer to page 4-63.
Refer to page 4-63.
Refer to page 4-63.
Refer to page 4-63.
Sets the recording trigger position. Refer to page 4-39 for details.
(This setting is not valid when the recording trigger mode is BURST,
MULTI1~3 and LINEAR. Change the Rec trigger mode to something
other than BURST, MULTI1~3 and LINEAR to set.)
Sets the START trigger position.
Sets the CENTER trigger position.
Sets the END trigger position.
Displayed when the fx camera is set to BURST recording.
Sets the CUSTOM trigger position.
Shutter Speed (values that can be set vary by model)
Record at shutter speed of 1/frame rate.
Record at 2k shutter speed.
Record at 5k shutter speed.
Record at 5k shutter speed.
Record at 10k shutter speed.
Record at 20k shutter speed.
Record at 50k shutter speed.
Record at 100k shutter speed.
Record at 200k shutter speed.
Record at a speed with a CUSTOM setting.
Setting where the low light mode preview brightness corresponds to the frame
rate.
(If using multiple camera heads with the GX-5/GX-5F, the ON/OFF status for the
low light mode is the same for all camera heads. However, if the individual
settings are OFF->ON or ON->OFF, all of the camera heads can be switched
ON/OFF. Also, if the exposure timing setting is "GX NATIVE", all of the camera
heads will have the same frame rate (exposure time) during the low light mode.
Low light mode is turned OFF.
Live image displayed corresponding to a frame rate of 100pps.
Live image displayed corresponding to a frame rate of 250pps.
Live image displayed corresponding to a frame rate of 500pps.
Live image displayed corresponding to a frame rate of 1000pps.
Live image displayed corresponding to the desired frame rate.
Exposure time units can be specified in PPS or microSEC.
Select the sensor gain. Can be set with the HX Camera.
Use the automatic exposure function or the image trigger function and
select the range for detecting the brightness. Refer to page 4-46 for details.
Select the image trigger function. Set with the GX camera.
Refer to page 4-51 for details.
4 - 19