Tunneling; Configuring A Tunnel - Dell Z9500 Configuration Manual

Z-series core and aggregation switche
Hide thumbs Also See for Z9500:
Table of Contents

Advertisement

Tunnel interfaces create a logical tunnel for IPv4 or IPv6 traffic. Tunneling supports RFC 2003, RFC 2473, and 4213.
DSCP, hop-limits, flow label values, open shortest path first (OSPF) v2, and OSPFv3 are supported. Internet control message
protocol (ICMP) error relay, PATH MTU transmission, and fragmented packets are not supported.
Topics:

Configuring a Tunnel

Configuring Tunnel Keepalive Settings
Configuring a Tunnel Interface
Configuring Tunnel Allow-Remote Decapsulation
Configuring Tunnel source anylocal Decapsulation
Guidelines for Configuring Multipoint Receive-Only Tunnels
Multipoint Receive-Only Tunnels
Configuring a Tunnel
You can configure a tunnel in IPv6 mode, IPv6IP mode, and IPIP mode.
If the tunnel mode is IPIP or IPv6IP, the tunnel source address and the tunnel destination address must be an IPv4 address.
If the tunnel mode is IPv6, the tunnel source address and the tunnel destination address must be an IPv6 address.
If the tunnel mode is IPv6 or IPIP, you can use either an IPv6 address or an IPv4 address for the logical address of the tunnel,
but in IPv6IP mode, the logical address must be an IPv6 address.
The following sample configuration shows a tunnel configured in IPv6 mode (carries IPv6 and IPv4 traffic).
Dell(conf)#interface tunnel 1
Dell(conf-if-tu-1)#tunnel source 30.1.1.1
Dell(conf-if-tu-1)#tunnel destination 50.1.1.1
Dell(conf-if-tu-1)#tunnel mode ipip
Dell(conf-if-tu-1)#ip address 1.1.1.1/24
Dell(conf-if-tu-1)#ipv6 address 1::1/64
Dell(conf-if-tu-1)#no shutdown
Dell(conf-if-tu-1)#show config
!
interface Tunnel 1
ip address 1.1.1.1/24
ipv6 address 1::1/64
tunnel destination 50.1.1.1
tunnel source 30.1.1.1
tunnel mode ipip
no shutdown
The following sample configuration shows a tunnel configured in IPV6IP mode (IPv4 tunnel carries IPv6 traffic only):
Dell(conf)#interface tunnel 2
Dell(conf-if-tu-2)#tunnel source 60.1.1.1
Dell(conf-if-tu-2)#tunnel destination 90.1.1.1
Dell(conf-if-tu-2)#tunnel mode ipv6ip
Dell(conf-if-tu-2)#ipv6 address 2::1/64
Dell(conf-if-tu-2)#no shutdown
Dell(conf-if-tu-2)#show config
!
55

Tunneling

Tunneling
832

Advertisement

Table of Contents
loading

Table of Contents