Vrf Configuration Notes - Dell Z9500 Configuration Manual

Figure 132. VRF Network Example

VRF Configuration Notes

Although there is no restriction on the number of VLANs that can be assigned to a VRF instance, the total number of routes
supported in VRF is limited by the size of the IPv4 CAM.
VRF is implemented in a network device by using Forwarding Information Bases (FIBs).
A network device may have the ability to configure different virtual routers, where entries in the FIB that belong to one VRF
cannot be accessed by another VRF on the same device. Only Layer 3 interfaces can belong to a VRF. VRF is supported on
following types of interface:
• Physical Ethernet interfaces
• Port-channel interfaces (static & dynamic using LACP)
• VLAN interfaces
• Loopback interfaces
VRF supports route redistribution between routing protocols (including static routes) only when the routes are within the same
VRF.
Dell Networking OS uses both the VRF name and VRF ID to manage VRF instances. The VRF name and VRF ID number are
assigned using the ip vrf command. The VRF ID is displayed in show ip vrf command output.
The VRF ID is not exchanged between routers. VRF IDs are local to a router.
VRF supports some routing protocols only on the default VRF (default-vrf) instance.
supported in VRF and whether they are supported on all VRF instances or only the default VRF.
Table 1 displays the software features
Virtual Routing and Forwarding (VRF) 854