Rip Configuration Example - Dell Z9500 Configuration Manual

Exercise caution when applying an offset command to routers on a broadcast network, as the router using the offset
command is modifying RIP advertisements before sending out those advertisements.
The distance command also allows you to manipulate route metrics. To assign different weights to routes so that the ones
with the lower weight or administrative distance assigned are preferred, use the distance command.
To set route matrixes, use the following commands.
• Apply a weight to all routes or a specific route and ACL.
ROUTER RIP mode
distance weight [ip-address mask [access-list-name]]
Configure the following parameters:
– weight: the range is from 1 to 255. The default is 120.
– ip-address mask: the IP address in dotted decimal format (A.B.C.D), and the mask in slash format (/x).
– access-list-name: the name of a configured IP ACL.
• Apply an additional number to the incoming or outgoing route metrics.
ROUTER RIP mode
offset-list access-list-name {in | out} offset [interface]
Configure the following parameters:
– prefix-list-name: the name of an established Prefix list to determine which incoming routes are modified
– offset: the range is from 0 to 16.
– interface: the type, slot, and number of an interface.
To view the configuration changes, use the show config command in ROUTER RIP mode.
Debugging RIP
The debug ip rip command enables RIP debugging.
When you enable debugging, you can view information on RIP protocol changes or RIP routes.
To enable RIP debugging, use the following command.
•
debug ip rip [interface | database | events | trigger]
EXEC privilege mode
Enable debugging of RIP.
Example of the debug ip rip Command
The following example shows the confirmation when you enable the debug function.
Dell#debug ip rip
RIP protocol debug is ON
Dell#
To disable RIP, use the no debug ip rip command.

RIP Configuration Example

The examples in this section show the command sequence to configure RIPv2 on the two routers shown in the following
illustration — Core 2 and Core 3.
The host prompts used in the following example reflect those names. The examples are divided into the following groups of
command sequences:
Routing Information Protocol (RIP) 699