Checking, Disassembling And Servicing - wsm M8540NARROW Workshop Manual

M8540Narrow, M9540Narrow, WSM

3. CHECKING, DISASSEMBLING AND SERVICING

[1] CHECKING AND ADJUSTING
[2] DISASSEMBLING AND ASSEMBLING
(1) Turning Angle Inspection Switch
Front Wheel Steering Angle
1. Inflate the tires to the specified pressure.
2. Steer the wheels to the extreme left until the front gear case (1)
touches with the stopper bolt (2) at right hand side of the front
axle and measure the steering angle (A).
3. Steer the wheels to the extreme right until the front gear case
(1) touches with the stopper bolt (2) at left hand side, and
measure the steering angle (A).
4. If the steering angle is not within the factory specifications, be
sure to adjust it by changing the number of the adjusting
washers (3).
Steering angle (A)
between front gear case Factory specification
and stopper bolt
(1) Front Gear Case
(2) Stopper Bolt
(3) Adjusting Washer
Turning Angle Inspection Switch
1. Remove the cover (2).
2. Remove the turning angle inspection switch (1).
(When reassembling)
• Adjust the turning angle inspection switch operating angle with
adjusting shim (3).
Turning angle inspection
Factory specification
switch operating angle
• Shim (3)
0.5 mm (0.02 in.): 3A481-40470
1.0 mm (0.039 in.): 3A481-40460
NOTE
• Remove the turning angle inspection switch to execute the
"Separating Front Axle" and "Disassembling Front Axle".
(1) Turning Angle Inspection Switch
(2) Cover
N6-S3
FRONT AXLE
0.646 to 0.680 rad
37.0 to 39.0 °
(A) Steering Angle
9Y1210236FAS0003US0
0.53 to 0.59 rad
30 to 34 °
(3) Adjusting Shim
9Y1210236FAS0004US0
KiSC issued 07, 2013 A