Clutch Housing; Creep Gear Assembly - wsm M8540NARROW Workshop Manual

M8540Narrow, M9540Narrow, WSM

[6] CLUTCH HOUSING

(1) Creep Gear Assembly

(2) 1st Shaft, 2nd Shaft and 3rd Shaft
Creep Gear
1. Remove the creep gear cover (2) as a unit.
2. Remove the internal circlip (1).
3. Tap out the creep gear shift (4) and remove the creep gear (3).
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face.
Tightening torque Creep gear cover
(1) Internal Circlip
(2) Creep Gear Cover
37T Gear
1. Remove the external circlip (2) and 37T gear (1).
(When reassembling)
• Check the clearance "L" between external circlip (2) and
adjusting collar (3).
• If the measurement is not within the factory specification, adjust
with shim.
(Reference)
• Thickness of adjusting collar (3).
3.00 mm (0.118 in.) [Code No.: 3C001-28410]
3.2 mm (0.126 in.) [Code No.: 3C001-28420]
3.4 mm (0.134 in.) [Code No.: 3C001-28430]
3.6 mm (0.142 in.) [Code No.: 3C001-28441]
Clearance "L" Factory specification
(1) 37T Gear
(2) External Circlip
(3) Adjusting Collar
N3-S16
TRANSMISSION
48.1 to 55.8 N·m
4.9 to 5.7 kgf·m
35.5 to 41.2 lbf·ft
(3) Creep Gear
(4) Creep Gear Shaft
9Y1210236TRS0023US0
Less than
0.2 mm
0.0078 in.
L: Clearance
9Y1210236TRS0024US0
KiSC issued 07, 2013 A