Removing Air Conditioner Pipes - wsm M8540NARROW Workshop Manual

M8540Narrow, M9540Narrow, WSM

(5) Removing Air Conditioner Pipes

Discharging Refrigerant Gas
Refer to "5. CHECKING AND CHARGING REFRIGERANT
CYCLE" at "10. CABIN" section.
Battery, Skirt and Bonnet
1. Open the bonnet (1) and disconnect the battery negative cable
(2).
2. Disconnect the head light connector (5) and remove the bonnet
cylinders (4).
3. Remove the skirts (3) L.H. and R.H..
4. Remove the bonnet (1).
NOTE
• When disconnecting the battery cords, disconnect the
negative cord first, when connecting, positive cord first.
(1) Bonnet
(2) Battery Negative Cable
(3) Skirt
High Pressure Hose 1
1. Disconnect the high pressure hose 1 (2) from the compressor
(1) and condenser (3), then cap the open fittings immediately to
keep moisture out of the system.
(When reassembling)
• Apply compressor oil (DENSO ND-OIL 8 or equivalent) to the
O-rings and take care not to damage them.
High pressure pipe 1
Tightening torque
mounting screw
(1) Compressor
(2) High Pressure Hose 1
N10-S20
9Y1210236CAS0037US0
(4) Bonnet Cylinder
(5) Head Light Connector
9Y1210236CAS0038US0
7.95 to 11.7 N·m
0.810 to 1.20 kgf·m
5.86 to 8.67 lbf·ft
(3) Condenser
9Y1210236CAS0039US0
KiSC issued 07, 2013 A
CABIN