wsm M8540NARROW Workshop Manual page 293

M8540Narrow, M9540Narrow, WSM
Removing Control Rods and Brake Hoses
1. Remove the main shift rod (2) and select wire (3).
2. Remove the Hi-Lo rod (1).
3. Remove the position control rod (4) and draft control rod (5).
4. Remove the lowering speed adjusting rod (7).
5. Remove the differential rod (6).
6. Remove the brake hoses for both side.
(When reassembling)
• Check the shift condition for main speed change and Hi-Lo shift.
• Be sure to bleed the air from hydraulic brake system. (Refer to
the "N5. BRAKE" section.)
Hi-Lo rod length "L1"
Main shift rod length "L2"
Reference
Position control rod length
"L3"
Draft control rod length
"L4"
(1) Hi-Lo Rod
(2) Main Shift Rod
(3) Select Wire
(4) Position Control Rod
Auxiliary Control Valve Cable and Ground Cable
1. Remove the auxiliary control valve cable (1).
2. Disconnect the ground harness (2).
(1) Auxiliary Control Valve Cable
N10-S15
300 mm
11.8 in.
655 mm
25.8 in.
262 mm
10.3 in.
235 mm
9.25 in.
(5) Draft Control Rod
(6) Differential Rod
(7) Lowering Speed Adjusting Rod
9Y1210236CAS0027US0
(2) Ground Harness
9Y1210236CAS0028US0
KiSC issued 07, 2013 A
CABIN