wsm M8540NARROW Workshop Manual page 215

M8540Narrow, M9540Narrow, WSM
Draft Floating Range Check
1. Attach the weight (2) of approx. 490 N (50 kgf, 110 lbf) to the
end of the lower links.
2. Attach the test bar (1) to the top link bracket (3).
3. Start the engine and set the speed at maximum speed.
4. Move the draft and position control lever (5), (4) all the way
down.
5. Press the test bar (1) downward until the top link bracket (3)
comes in contact with the body.
6. Slowly shift the draft control lever (5) upward until the lift arms
begin to rise. Then slowly shift the draft control lever (5)
downward until the lift arms begin to down, measure the floating
range "L" of the draft control lever (5) from the end of the lever
guide (6).
7. If floating range "L" is not within the factory specification, adjust
the draft control rod.
Floating range "L" Factory specification
(1) Test Bar
(2) Weight
(3) Top Link Bracket
(4) Position Control Lever
(5) Draft Control Lever
(6) Lever Guide
N8-S13
HYDRAULIC SYSTEM
More than
15.0 mm
0.59 in.
[A] ROPS Model
[B] CABIN Model
L: Floating Range
9Y1210236HYS0011US0
KiSC issued 07, 2013 A