Removing Differential Gear And Bevel Pinion Shaft - wsm M8540NARROW Workshop Manual

M8540Narrow, M9540Narrow, WSM

(3) Removing Differential Gear and Bevel Pinion Shaft

Removing PTO Clutch Pack and Holder
1. Draw out the pin (2) with sliding hammer (3). (Refer to "8.
SPECIAL TOOLS" at "G. GENERAL" section.)
2. Take out the hydraulic pump drive gear (1).
3. Remove the PTO clutch holder mounting screws.
4. Remove the PTO clutch (4) with holder (5).
(When reassembling)
• Take care not to damage the hydraulic pipes.
PTO clutch holder
Tightening torque
mounting screw
IMPORTANT
• After assembling the PTO clutch assembly, be sure to
check the piston operation by air-pressure.
(1) Gear
(2) Pin
(3) Sliding Hammer
Brake Cam Plate
1. Remove the return spring (1).
2. Remove the brake cam plate (2).
(When reassembling)
• Apply grease to the brake ball seats. (Do not apply excessively.)
• Be sure to assemble the brake cam plate (2) to the original side,
refer to the I.D. mark R and L.
(1) Return Spring
(2) Brake Cam Plate
(3) Ball
N3-S26
TRANSMISSION
23.5 to 27.4 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 lbf·ft
(4) PTO Clutch
(5) Holder
9Y1210236TRS0037US0
a: I.D. Mark
9Y1210236TRS0038US0
KiSC issued 07, 2013 A