Sirona Dental Systems Gmbh - Sirona SiroLaser advance Operating Instructions Manual

Sirona Dental Systems GmbH

Operating Instructions SIROLaser Advance
There occurred an error due
to a defective finger switch
or wireless foot control
which could not be handled.
Please contact Sirona
Dental Systems GmbH,
your local dental depot or
your authorized service
center. Confirmation via
'OK'.
There occurred an error due
to overheating which could
not be handled. Please
contact Sirona Dental
Systems GmbH, your local
dental depot or your
authorized service center.
Confirmation via 'OK'.
62 60 504 D3545
D3545.201.01.08.02 08.2012
There occurred an error
about the initialization of the
EEPROM which could not
be handled. Please contact
Sirona Dental Systems
GmbH, your local dental
depot or your authorized
service center.
Confirmation via 'OK'.
There occurred an error to
the photo diode inside the
handpiece which could not
be handled. Please contact
Sirona Dental Systems
GmbH, your local dental
depot or your authorized
service center.
Confirmation via 'OK'.
There occurred an error
about the EEPROM
communication which could
not be handled. Please
contact Sirona Dental
Systems GmbH, your local
dental depot or your
authorized service center.
Confirmation via 'OK'.
The fiber could not be
detected. See chapter
"Troubleshooting ..." [➙ 66].
Confirmation via 'OK'.
Operation
Main home screen
Cooling fan is not working.
To avoid damage please
switch off the SIROLaser
Advance and let it cool
down for a while. See
chapter "Troubleshooting
..." [ ➙ 66].
There occured an error
because the user wants to
set the duty cycle below
10% or above 90% at a
frequency above 1 kHz.
Due to physical limits, this is
not possible. Confirmation
via 'OK'.
53