Axis Settings - Omron NJ501-4500 Manual

3 Setting Robot Functions
Parameter name
Maximum Interpo-
lation Velocity
Maximum Interpo-
lation Acceleration
Maximum Interpo-
lation Deceleration
Interpolation Accel-
eration/Decelera-
tion Over
Interpolation Veloc-
ity Warning Value
Interpolation Accel-
eration Warning
Value
Interpolation
Deceleration Warn-
ing Value
Axes Group Stop
Method
Correction Allow-
ance Ratio
Precautions for Safe Use
Select Immediate stop or Immediate stop and Servo OFF when using Delta 3, Delta 3R, Delta
2, Cartesian 2D Gantry or Cartesian 3D Gantry robot.
3-1-3

Axis Settings

Use the Sysmac Studio to set the axis parameters for each axis.
When axes of the robot operates separately, each axis operation follows its Axis Settings. The settings
of three axes must be the same.
If you use the MC_SyncLinearConveyor (Start Conveyor Synchronization) instruction, you must also
set the conveyor axes.
3 - 4
Setting
Set the maximum interpolation velocity for the
trajectory.
Set the maximum interpolation acceleration for
the trajectory.
Set the maximum interpolation deceleration for
the trajectory.
Select the operation for when the maximum
interpolation acceleration/deceleration may be
exceeded after excessive deceleration during
the axes group acceleration/deceleration control
because stopping at the target position is given
priority.
Set the percentage of the maximum interpola-
tion velocity at which to output an interpolation
velocity warning.
Set the percentage of the maximum interpola-
tion acceleration at which to output an interpola-
tion acceleration warning.
Set the percentage of the maximum interpola-
tion deceleration rate at which to output an inter-
polation deceleration warning.
Set how to stop the composition axes that have
no error when an error that forces an immediate
stop occurs in an axis during a multi-axes coor-
dinated motion.
This parameter applies when the center desig-
nation method is used for a circular interpolation
instruction. It compensates the distance when
the distance between the start point and the
center point does not equal the distance
between the end point and the center point.
Set value
Use the default value.
Use the default value.
NJ-series NJ Robotics CPU Unit User's Manual (W539)