Displaying And Maintaining The Tftp Client; Tftp Client Configuration Example - HP 830 Series Configuration Manual

IMPORTANT:
If you specify a source interface for TFTP packets, make sure the interface has been assigned a primary IP
address. Otherwise, the TFTP connection cannot be established.
To use the device as a TFTP client:
Step
1. Enter system view.
2. Use an ACL to control the
client's access to TFTP servers.
3. Specify a source IP address
for outgoing TFTP packets.
4. Return to user view.
5. Download or upload a file.

Displaying and maintaining the TFTP client

Task
Display the source IP address configuration
of the TFTP client.

TFTP client configuration example

The configuration example was created on the 10500/7500 20G unified wired-WLAN module and
might vary with device models.
When configuring the 10500/7500 20G unified wired-WLAN module, make sure the settings are
correct (including VLAN settings) on the internal Ethernet interface that connects the module to the switch.
For more information, see HP 10500/7500 20G Unified Wired-WLAN Module Fundamentals
Configuration Guide.
Command
system-view
tftp-server [ ipv6 ] acl acl-number
tftp client source { interface
interface-type interface-number | ip
source-ip-address }
quit
•
For IPv4:
tftp server-address { get | put |
sget } source-filename
[ destination-filename ] [ source
{ interface interface-type
interface-number | ip
source-ip-address } ]
•
For IPv6:
tftp ipv6 tftp-ipv6-server [ -i
interface-type interface-number ]
{ get | put } source-filename
[ destination-filename ]
Command
display tftp client configuration [ |
{ begin | exclude | include }
regular-expression ]
71
Remarks
N/A
Optional.
By default, no ACL is used for
access control.
Optional.
By default, the primary IP
address of the output interface is
used as the source IP address.
N/A
Optional.
Remarks
Available in any
view.