Configuring Source Ip-Based Web Login Control; Logging Off Online Web Users; Web Login Control Configuration Example - HP 830 Series Configuration Manual

Poe+ unified wired-wlan switch
Hide thumbs Also See for 830 Series:
Table of Contents

Advertisement

Configuring source IP-based Web login control

Step
1.
Enter system view.
2.
Create a basic ACL and enter
its view, or enter the view of
an existing basic ACL.
3.
Create rules for this ACL.
4.
Exit the basic ACL view.
5.
Associate the ACL with the
HTTP or HTTPS service.

Logging off online Web users

Task
Log off online Web users.

Web login control configuration example

The configuration example was created on the 10500/7500 20G unified wired-WLAN module and
might vary with device models.
When configuring the 10500/7500 20G unified wired-WLAN module, make sure the settings are
correct (including VLAN settings) on the internal Ethernet interface that connects the module to the switch.
For more information, see HP 10500/7500 20G Unified Wired-WLAN Module Fundamentals
Configuration Guide.
By default, the aggregate interfaces between the access controller engine and the switching engine on
an 830 switch are Access interfaces in VLAN 1. When configuring the two aggregate interfaces, make
sure their permitted VLANs are the same. HP also recommends setting their link type to be the same.
Network requirements
Configure the AC in
Command
system-view
acl [ ipv6 ] number acl-number
[ match-order { config | auto } ]
rule [ rule-id ] { deny | permit }
[ counting | fragment | logging |
source { sour-addr sour-wildcard |
any } | time-range
time-range-name ] *
quit
To associate the ACL with the
HTTP service:
ip http acl acl-number
To associate the ACL with the
HTTPS service:
ip https acl acl-number
Command
free web-users { all | user-id user-id |
user-name user-name }
Figure 22
to provide Web access service only to Host B.
58
Remarks
N/A
By default, no basic ACL exists.
N/A
N/A
Configure either or both of the
commands.
HTTP login and HTTPS login are
separate login methods. To use
HTTPS login, you do not need to
configure HTTP login.
Remarks
Available in user interface
view.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

105007500

Table of Contents